2016-02-28 (Su) Simple Recumbent Bike Without Welding

The joints made yesterday were attached as hanging pieces. This seemed the most logical way to attach them since gravity and pedaling pressure would push them down. This was a secure method of attaching the pieces but the upper frame was still too low and could allow the pedals to interfere with the front wheel.

Joints attached to upper frame

All bolts were loosened and the joint was spun 180º so the upper frame would point up more than before. Clearance between the pedals and wheel was increased, hopefully enough to clear feet from the wheel.

Joints attached upside-down for elevation

Hardware wasn’t aligned properly so the upper frame was not pointed correctly. Washers had to be added to hold the frames parallel. The washers helped but added distance between the bike frames. This wasn’t a problem for leg clearance.

Upper frame not parallel to lower frame

Distance between the bike frames lead to a small problem with the short threaded rods being used. They were too short to reach between the fastening hardware on each side. This can be quickly solved with long threaded rods or, most likely, trimmed bolts.

Threaded rod too short

To do:
  • Permanently attach upper frame
  • Remove cranks from lower bike
  • Run chain between cranks and wheel
  • Construct idler sprocket
  • Test
  • Strip pink paint
  • Repaint

The rest of the posts for this project have been arranged by date.

First time here?

Completed projects from year 1.
Completed projects from year 2



This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.

All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.

All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.

Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.

This blog, including pictures and text, is copyright to Brian McEvoy.

2016-02-28 (Su)

Comments

  1. Very much informative for bike frame that adds more value in this blog...

    ReplyDelete
  2. A bike without welding seems like a good idea, but how much strong it is? What do you think how sustainable will it be? Thanks in advance.

    ReplyDelete

Post a Comment