Rotating view of model
Two of the parts were meant to travel along threaded rods. These holes were tapped so they could accept the threads. A standard 4-40 tap was used but a metric size and a metric threaded rod would work as well.
Threading a printed part
All the parts were assembled with the threaded rod and some short bolts. The short bolts were not visible but they hold the hollow rectangle to the pieces below.
After assembly, it became clear the design would not fit on the glasses frame. A smaller design will have to be created for it to work.
Glasses with the parts that won't fit
The rest of the posts for this project have been arranged by date.
First time here?
Completed projects from year 1.
Completed projects from year 2.
Completed projects from year 3.
Disclaimer for http://24hourengineer.blogspot.com/
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address firstname.lastname@example.org becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.