I printed two copies of my drafted template and figured I could arrange them on a 12" x 12" sheet of polycarbonate. When I moved them around, I found I could fit four copies after I cut them out of paper. I sprayed the plastic sheet with Super77 and let it dry for a moment before sticking down the templates. I cut out two, drilled one of the 1/4" holes, and then bolted them together. I made a second hole through the firmly attached pieces and secured it with another bolt. I continued until I completed all the bolt holes, so I am confident everything will line up.
The motor mounting holes were different since I only needed them in one side. There were eight orbiting the shaft hole, and they were very close together, but at 4 mm, they were no trouble. The center had to be at least 10 mm wide, which was my largest metric bit, but I accurately placed it, so I cut it.
The rest of the posts for this project have been arranged by date.
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Completed projects from year 4
Completed projects from year 5
Completed projects from year 6
Completed projects from year 7
Completed projects from year 8
Disclaimer for http://24hourengineer.blogspot.com and 24HourEngineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information on this blog, or linked by this blog, is not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property, or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2022-10-22
The motor mounting holes were different since I only needed them in one side. There were eight orbiting the shaft hole, and they were very close together, but at 4 mm, they were no trouble. The center had to be at least 10 mm wide, which was my largest metric bit, but I accurately placed it, so I cut it.
The rest of the posts for this project have been arranged by date.
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Completed projects from year 4
Completed projects from year 5
Completed projects from year 6
Completed projects from year 7
Completed projects from year 8
Disclaimer for http://24hourengineer.blogspot.com and 24HourEngineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information on this blog, or linked by this blog, is not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property, or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2022-10-22
Comments
Post a Comment