2023-07-06 (Th) KeyRyptex Third model

I liked the petite version, and the parts fit onto one sheet of plywood. I revised the design to use a single tab between each keyswitch hole so I would not have three flimsy tabs. The top and bottom also have one tab per side, so the visible surfaces do not look perforated. I switched to four magnets holding the bottom cover because six was too strong and required two tape strips to cover everything. I put a hole in the top that would fit a 5mm LED bezel.
Rev3 parts

The pieces did not fit together as securely this time, probably because there were fewer tabs and slots. I may have to glue the parts after I install the electronics. I like how the single LED on the top looks.
First three models

The rest of the posts for this project have been arranged by date.
First time here?

Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Completed projects from year 4
Completed projects from year 5
Completed projects from year 6
Completed projects from year 7
Completed projects from year 8

Disclaimer for http://24hourengineer.blogspot.com and 24HourEngineer.com

This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.

All information on this blog, or linked by this blog, is not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property, or similar, is the responsibility of those involved in the replication.

All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by  Brian McEvoy, cannot be used to claim property or assets.

Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on their post.

This blog, including pictures and text, is copyright to Brian McEvoy.
2023-07-04

Comments